Dimensions {Inches (mm)}

The CH gives infinite control for noninductive loads up to 15 Amps on 120 or 240 Vac (cannot be used with an external contactor). It can be turned either to left or right to select proper heat from 0-100% wattage with infinite control over the first 50% of total wattage.  Energized continuously in HI position, at other settings it delivers selected input level under control of a simple bimetal timer.  Only 3 mounting holes are necessary to install the CH in customer supplied box or panel. It is designed for use at ambient temperatures up to 180°F.

• Simplicity of design with no cams or levers to adjust, and no motor to burn out.
• Automatic compensation for line voltage fluctuations up to ± 15%.
• Bimetal acts at settings less than HI to limit electrical input and depress temperature.

WARNING: Hazard of Fire. These devices function as energy controls only. Because they do not fail-safe, an approved temperature and/ or pressure safety control must be used for safe operation.

We are a Distributor of Industrial, Commercial and Residential Heaters and Controls. Always consult manufacturers installation instructions for proper installation of the products or systems shown on this website. © Copyright 1999-2019 Mor Electric Heating Assoc., Inc.

MOR ELECTRIC HEATING ASSOC., INC.
5880 Alpine Ave. NW - Comstock Park, MI 49321  USA
Tel 616-784-1121 - 800-442-2581 - Fax 616-784-7775
E-mail: sales@heatersplus.com